SAM BOOST™ WITH SMART NOZZLE N
Follow your jurisdiction's SOP for hydrant or draft changeover
1. Put pump into desired Governor mode
a. Some SOPs require the need to switch to RPM mode during changeover events. While in
RPM mode, the Smart Nozzle will lose control since the system is governed by RPM
instead of pressure. Returning to PSI Mode will restore Smart Nozzle control
2. Establish the water source following your jurisdiction's SOP
a. Use the + and – buttons at the top of the screen to control tank to pump valve and close
when appropriate.
6.2.5
SAM Smart Nozzle Override
Sheet: FSG-MNL-00234
INSTALLATION, OPERATING, & MAINTENANCE MANUAL
PHONE: (800) 288.1161
www.akronbrass.com
Revision 2023-08-28
P AND UV780 DISPLAY
2
Page: 42 of 66