SAM BOOST™ WITH SMART NOZZLE N
It is recommended to install the module such that electric connectors are oriented
downward or sideways to avoid water build-up and intrusion.
5.8.1
Pressure Transducer Installation
Included with the kit are calibrated Master Intake and Master Discharge pressure transducers. Locate and
replace the original equipment Master pressure transducers with the new ones. Following the steps below:
□
Located Original Equipment Master Intake & Discharge Pressure Sensors
•
Note that some systems may not have Master intake transducers
▪
□
Remove Original Equipment Master Intake & Discharge Pressure Sensors
□
Install SAM Boost™ pressure transducers
Sheet: FSG-MNL-00234
INSTALLATION, OPERATING, & MAINTENANCE MANUAL
If the truck did not originally include a Master Intake pressure transducer, locate a ¼"
NPT port on the suction side of the pump
PHONE: (800) 288.1161
www.akronbrass.com
Revision 2023-08-28
P AND UV780 DISPLAY
2
Page: 30 of 66