Pre-Operation Check - Toyota 7FG35 Operator's Manual

q Unlock
w Remove
20
(5) The trapping indicator lamps go out in se-
quence from right to left (yellow / green) as
maintenance proceeds. (every 10 minutes)
(6) Once maintenance is over, all the indicator
lamps go out and maintenance automatically
stops.
Note: The recovering time is about 50 minutes
when the green trapping indicator lamps (up to
5) light and about 70 minutes when the yellow
trapping indicator lamp lights.
(7) Be sure to remove the power plug.
Caution
Soot combustion interruption (Maintenance
interruption)
Plugging out the power cable during soot
combustion will cause the buzzer to sound and
the trapping indicator lamp will come on af-
ter one minute. In such a case, plug in the
power cable immediately when the buzzer
sounds. When interrupting soot combustion
in progress is unavoidable, press the mainte-
nance switch for about 5 seconds until the
buzzer sounds. Then, the left green lamp and
the maintenance lamp will come on. After
about five minutes, when all the indicator
lamps are off, the engine can be activated
again. Plug out the power cable after the
maintenance lamp is off. Do not interrupt soot
combustion unless unavoidable as next soot
combustion will be required earlier due to
combustion remains.

PRE-OPERATION CHECK

Pre-operation check
Pre-operation checks and weekly inspections are
the responsibility of the Toyota industrial vehi-
cle user.
Be sure to perform a pre-operation check be-
fore beginning work to ensure safety.
Item Inspection
Previously detected malfunctions Correct.
Exterior Vehicle body, oil leakage,
water leakage, loose parts,
exterior damage.
Wheels Tire pressure, wear or
damage, rims hub nuts.
Lamps Lamp condition, damaged
lamps.
Hydraulic oil Oil level, contamination,
consistency.
Radiator Coolant level, antifreeze
requirement.
Engine Oil level, contamination,
consistency, noise, exhaust.
Clutch Engagement, pedal, play.
Brake pedal Pedal play, braking effect.
Brake fluid Fluid level.
Parking brake Operating force, braking
effect.
Steering wheel Looseness, play, vibration,
veering.
Horn Sound.
Instruments Functioning.
Load handling system Parts, oil leakage, cracking,
looseness.
Make certain that the SAS
is functioning.
Fuel Amount.
Walk around inspection
Vehicle uprightness
Does the vehicle lean to one side or the other?
If so, check for a tire puncture or a problem with
the undercarriage.