Toyota 7FG35 Operator's Manual page 14

q Forward
w Backward
q Automatic fork leveling switch
Tilt lever
Tilts the mast forward and backward.
Forward ..................................... Push forward
Backward ................................ Pull backward
Forward or backward tilting speed can be
adjusted by the extent of pressing the accelerator
pedal and operating the lever.
Automatic fork leveling switch
(Works same as the tilt lever knob
switch.)
With this switch ON (being pressed), if you
change tilting from backward to forward, the
forks will automatically stop at their horizontal
position.
It is also possible to slow down the backward
tilt speed at a low lift.
Automatic fork leveling control
With the automatic fork leveling switch ON, use
the tilt lever to move the mast from backward
tilt position to forward tilt position. Then, the
mast can be automatically stopped with the forks
horizontally positioned. This feature is
convenient for loading and pulling in and out
the forks.
Motion upon change of tilt from backward to
forward, with the automatic fork leveling switch
ON:
Not Loaded Loaded
High Lift Forks stopped at their horizontal
Not tilting
position (with mast vertically
forward
positioned)
Low Lift Forks stopped at their horizontal position
(with mast vertically positioned)
Highest Not tilting forward
position
q Attachment lever
Mast backward tilt speed control
While the automatic fork leveling switch is
turned ON, backward tilt speed for the forks is
slowed down. The speed also becomes slow with
the forks lifted high, even though the switch is
not turned ON.
Note: Turn OFF the automatic fork leveling
switch, when the feature is not required.
Attachment lever
Operates the attachment.
Attachment speed can be adjusted by the extent
of pressing the accelerator pedal and operating
the lever.
13
En