Timer - devention DEVO 7E User Manual

Trainer
Inhibit
14 p.4 ;::"Tjrf
Timer
Ts,ipe
Set Tirm.?
Countd
cleUention
DEVO 7E
Welcome to use the DEVO 7E transmitter
Trainer icon
Training Status Display: when the trainer's icon turns to "X", the trainee stops flying and the trainer is working;
when the trainer's icon turns to",/", the trainee is flying and the trainer is in leisure.
(3) Usage
The default setting of the training switch is "R+" key.
During flight, if the trainer press" R+"key,the linkage icon will
be shown as "- N i" that means the control right is moved to the
trainee from trainer. If trainer pushes "R+" key once again,
the linkage icon will be show as "X" that means the trainer
takes back the control right from the trainee.
(4) Setting for training function channels
Trainee is available to get full or part of flight control power to the aircraft model via setting the training function
channel in the trainer's radio. Below is the Setup:
Press the ENT to Main Menu, use UP or DN to Function Menu. Use UP or DN to select Trainer and press
ENT to enter Trainer interface. The available channels are shown between Elevator, Aileron, Throttle, Rudder,
Gear, Pitch and Gyro, and the current status of trainer switch is also shown there.
Channel selection:
Press UP or DN to select the channel option; press R or L
to select the channel(s) which you want to grant to trainee.
The channels(s) you have selected will be activated as
"Active". The channel(s) which are not granted to trainee
will be kept inhibited. The default setting is "Inhibit'.
Press EXT to exit.
3.17 Timer
There are two timers on the DEVO 7E, stopwatch and countdown timer. These timers are activated by switch
or by shorcut.
Setup:
Press ENT to Main Menu, use UP or DN to Function Menu.
Press ENT to enter Function Menu. Use UP or DN to choose
Timer, and press ENT to enter Timer setting interface. The
factory default is Stopwatch, and the timing range of stopwatch
is from 0 to 60.
Timer
11
Type
Sto watch
(1) Countdown setting
Press R or L to select Countdown. There is an expand sub-
menu Set Time. Press UP or DN to Set Time interface, use
R or L to set up countdown time. The timing rang is from
00:10-to 60.
(2) Switch selection
Press UP or DN to move the navigational mark to Switch.There are Inhibit and available switch options, use
L or R to choose switches between FMOD SW,HOLD SW, SPSO SW, SPS1 SW, SPS2 SW and SPS3 SW.
Select the desired item except these items of SPSO SW, SPS1 SW, SPS2, and SPS3 which should be
previously set at Stick Position Switch at Model Menu(refer to "2.8 Stick Position Switch").
Press EXT after finished.
(3) Usage of timer
Use the UP key to start and stop the timer. Use DN to
reset the timer. You can also set switches to control the
timer. Below is the picture of timer display on the boot
screen .
MOD 1
DEVO 7E -
38