Table of Contents
Advertisement
:3ti
Direct'
0 11
Eleva.to
Aileron
N
0
rm al
cleention
DEVO 7E
Welcome to use the DEVO 7E transmitter
1.6 Stick Direction
Press ENT to enter into Main Menu; Press UP or DN to make
navigation mark at System menu. Press ENT to enter into
System menu; Press UP or DN to choose Stick direction,
press ENT to enter into Stick direction interface.
Stick Direction: There are four items available as Elevator,
Aileron, Throttle and Rudder. Press UP or DN to select the
stick which will change direction, and press R or L to change
the direction. The factory setting is Normal.
1.7 Stick Calibration
T he stick calibration used to re-calibration when stick unusual.
Enter the System Menu, use UP or DN to select Stick Calibration and press ENT to the Stick Calibration setup
interface. Press ENT to enter Calibration, the display will be as shown below:
Stick:.
al i b rati o n
Ethi
Stick:. Calibration
ENT to Calibrate
ENT to Calibrate
b r at i o
LI C :e: !E;
Press EXT to exit after finished.
ENT to Finis
Stick calibration: Move all of the control sticks to their
maximum and minimum levels several times, when complete,
return the sticks to their neutral positions.
Press ENT again to STOP the calibration process and the
display should show "START: SUCCESS".
If the display shows "STOP:ERROR", the calibration has
failed. Please go back to the STMOD sub-menu using EXT
and re-start the calibration process.
1.8 About
From the SYSTEM menu, use UP or DN to choose About
and press ENT to enter About interface. The firmware and
Library version will be displayed.
Press EXT to exit when finished.
2.0 Model Menu
0 LH
oftvyij, r k
r: a
Li b rary
r, 0,
Model Menu manages all the model data saved in DEVO 7E. It includes Model Select, Model Name, Model
Copy, Model Transmit, Model Receive, Model Reset, Type Select, Trim System, Stick Position Switch, Device
Select, Device Output, Swash Type, Fixed ID and Sensor setting.
2 .1 Model Selection
Press ENT to get Main Menu and press UP or DN to select Model Menu. Press ENT to get the Model Menu
and press UP or DN to select Model select, press ENT to get the Model Select setup interface.
Model Select
1311
2 81- tylf.DD 1
tyl D
4 4F5 tyl D 4
•
•
Press UP or DN until the desired model starts to flash. A total
of 30 model configurations can be stored. Press ENT to
confirm then EXT to exit
DEVO 7E -
42
Advertisement
Table of Contents
