Table of Contents
Advertisement
F' ro
9
ram NA iEn - 1 ' J
213
4 H
POird
P o nt —
I
Stat u s
1
F' ro
9
ram Ni i 1
Point
Point
-
1
3 t at u 3
Inhibit
0
t7
r
L 211 3 H
Welcome to use the DEVO 7E transmitter
de()ention
DEVO 7E
(2.1) Master(Main channel) Setup
Use UP or DN to select Master, press ENT to Master interface. Pressing UP or DN to select the desired
channel, there are Elevator, Aileron, Throttle, Rudder, Gear, Pitch, AUX2, #Elevator, #Aileron, #Pitch, #Rudder,
"Elevator, *Aileron, *Throttle, *Rudder, Flight Mode for choices. Press ENT to make a
".N1"
to confirm the
choosed item. Press EXT to go back to previous Program Mix 1 interface .
(2.2) Slave channel Setup
Press UP or DN to select Slave and press ENT to Slave interface. Use UP or DN to select the desired channel,
there are Elevator, Aileron, Throttle, Rudder, Gear, Pitch and Gyro for choices. Press ENT to make a "'1" to
confirm the choosed item. Press EXT to go back to previous Program Mix1 interface.
NA !F..; t r
leron
Thrutu
R
AL]
dder
laVb
,./Elevator
s'Id e in
Th rottl e
Rudder
(1.1) Master(Main channel) Setup
(1.2) Slave channel Setup
(2.3)
Exponential Curve Setup
Press UP or DN to choose the setting item of Exponential Curve .There are ON or OFF option when you
press the R or L buttoms. The Curve Pitch will become round if the ON buttom is choosen.If you don't adjust
the Pitch Curve Funtion, then choose OFF buttom.
(2.4) Point Setup
Press UP or DN to Point interface. Press R or L to select Point between Point-L,Point -1, Point -2, Point -M,
P oint -3, Point -4 and Point -H. Choose the desired point to adjust.
(2.5) State Setup:
(Remark: When Point choose point -L or point —H, there is no status shown in the menu) After selecting the point
that you want to set, press UP or DN to move the navigational mark to Status item. Press R or L, there are two
options of Inhibit and Active. Select Inhibit for unchanging the current amount (the default setting is Inhibit).
(2.4) Point Setup
(2.5) State Setup
(2.6) output setting
Press UP or DN to choose Output, Use R to increase point's output value, the maximun amount is +100%.
press L to decrease point' output value, the minimum amount is -100%.
(2.7) Switch Selection
Use UP or DN to choose Switch. Press ENT to enter the interface of Switch. There are Always On, Normal
Mode, Stunt Mode, Throttle Hold for permitted choices. Press UP or DN to choose the desired item. Press
ENT to confirm and marked with "
I ".
F' ro
9
ram Mix
1
0 utp ut
O
▪
WIL1 .1i
o
r
1
itc h
1162121 a ligillUmi""IN
Norm
o d
Stunt Mode
Throttle Hold
Press EXT to return to the previous interface or press EXT to exit after finished .
DEVO 7E —
35
Advertisement
Table of Contents
