Table of Contents
Advertisement
Master
Aileron
I ii
17.:!
A udder
V El e
Aileron
Throttle
Rudder
ociXention
DEVO 7E
Welcome to use the DEVO 7E transmitter
(1.2) Slave channel Setup
Press UP or DN to select Slave and press ENT to Slave interface. Use UP or DN to select the desired channel,there
are Elevator, Aileron, Throttle, Rudder, Gear, Pitch and Gyro for choices. Press ENT to make a
" -1"
to confirm
the choosed item. Press EXT to go back to previous Program Mix1 interface.
(1.1) Master(Main channel) Setup
(1.2) Slave channel Setup
(1.3)
Gain Setup
Once Main and Slave channels have been set, press DN to display the Gain setting. The gain setting controls
the slave channel output in proportion to the main channel setting. A higher gain value will result in a greater
change in output. A negative gain setting will result in a change in the opposite d irection with respect to the
main channel. Take Elevator as an example.
(1.3.1) UP Setup:
Mix amount setting when elevator stick moved upward.
Press UP or DN to move the navigational mark to select Up
to item.Use R/L to increase/decrease the mix amount. It is
possible to reverse mix direction through changing the + or
- sign before amount. The adjustable range is ±125%.
1.3.2) Down Setup:
Mix amount setting when elevator stick moved backward. Use
UP or DN to select Down item.Press R/L to increase/decrease the mix amount. It is possible to reverse mix
direction through changing the + or - sign before amount. The adjustable range is ±125%.
1.3.3) Offset Setup:
Using the Offset function it is possible to apply a slave channel correction even at the 0 position on the main
channel. It is also possible to enable or disable the Offset based on a designated switch position. Press DN
after setting 1.3.2 to display the Offset setting value. Use R and L as before to set the desired value. Use R
and L as before to set the desired value. The permitted adjustment range is -100% to +100%.
(1.4) Switch Selection
Use UP or DN to choose Switch. Press ENT to enter the interface of Switch.There are Always On, Normal
Mode, Stunt Mode,Throttle Hold for permitted choices. Press UP or DN to choose the desired item. Press
ENT to confirm and marked with
" .i
".
ogram
Offset
0 :TA
al Nilod
P
Stunt
Mode
Throttle Hold
(2) Curve Setting of Program Mix 1
Use UP or DN to select Curve, press ENT to confirm. Then the interface pop up "All Servos Hold?", Press R
or L to choose OK or Cancel. If select OK, all the servos will be locked in the current status, if select Cancel,
all servos are unlocked. Press ENT to setting interface of Program Mix1. The interface will show the setting
items and curve table as below :
Program Mix 1
p
VyTt L.
1°
1
Program Mix
1
.e2' % 11 s i Pr VO
H Ohl ?
M' l
.
C.:
ProgrEi.m
1
Master
0
-
I
'
L
L I 21113 H
Elevator
:z;Iavp
EIRvator
DEVO 7E —
34
Advertisement
Table of Contents
