Table of Contents
Advertisement
,6,1..e . 1 /C1 1J IJ r ?
-mainnvalummtnumosneimmuus
Axed ID
Status
On
ID code
1128188
Fixed ID
bJ
ID Match
Sensor Setting
:3Rnsor Status
Active
No Signal 1...Yarning
Inhibit
cleention
DEVO 7E
Welcome to use the DEVO 7E transmitter
Press ENT to change the code data, use R and L to change
the code values, press DN to move to the next digit, UP to
move to the previous digit. There are 6digits can be settled.
After setting the desired code press ENT, "RUN" will be
displayed. Use R or L to change NO to YES and press ENT
to confirm and execute the binding process. An inquiry
interface of "Are you sure?" pop up. "ID Code Matching ...
..." will be shown after press ENT. After binding the display
will return to the model menu automatically.
ID
(2) Cancelling/Resetting the Fixed ID
If you wish to change the receiver Fixed ID model back to random ID, insert the included BIND PLUG into
the output terminal BATT before the receiver is powered on. Connect 5V DC power to the Throttle channel.
The red LED of the receiver will flash slowly. Remove the BIND PLUG. The Fixed ID code has been cancelled.
After the receiver's Fixed ID is reset it should also be reset in the Transmitter. Here is the setup:
In the main interface press the ENT to enter Model
Menu and then press UP or DN to move the navigational
mark to select MODEL MENU. Press ENT to enter
MODEL MENU. Press UP or DN to select Fixed ID code
and press ENT key to enter the Fixed ID code interface.
Press UP or DN to select STATUS option, Press R or
L to change the status to Off. Then press EXT to exit.
2.13 Sensor Setup
Setting method: press ENT enter to the Main Menu. Press UP or DN to select the Model Menu. Press ENT
enter to Model Menu. Press UP or DN to select sensor press ENT enter to the sensor setting interface. See
the Illustration.
-:Prr;nr .
Sensor Status
Press R or L to select Activate or Inhibit (the default setting
is Inhibit), such as press Activate will includes No Signal
Waming,Voltage sensor,Temperature sensor, GPS receiver
setting etc.
Inhibit
(1) No Signal Warning
Press UP or DN to make the navigation mark to choose "No
Signal Warning". Press R or L to choose " Inhibit" or "Active"
(default setting is" inhibit"). If you choose "Active", the Radio
will alarm when telemetry signal lost. As following:
(2) Voltage Setup
There are 3 different types of voltage can be measured.It includes Internal 5V,External V1 and V2 which can
be monitored two different external voltage(i.e. battery) respectively. Once the measured voltage is lower
than the setting value, the Radio will alarm.
(2.1) Receiver 5V(Internal) PFV(Power Feeding Voltage) Alarmed value can be setted as 3.6-6V
Voltage Setup: press R or L to activate the 5V, the alarm interface will appear in the interface, please refer
to the Illustration.
DEVO 7E - 50
Advertisement
Table of Contents
