Table of Contents
Advertisement
t :21.to r
St u S
Inhibit
b r ato r
St at u s
......
1,1!
Mode
'2
o d e 3
f
mode 4
H I
1
Welcome to use the DEVO 7E transmitter
deVention
DEVO 7E
1.3 Buzzer Setup
Pressing ENT to enter the main menu, use UP or DN to select system menu, press ENT to enter System
menu. Use UP or DN to select Buzzer, press ENT to enter the buzzer interface.
(1) [SYSTEM/BUZZE/STATE] Buzzer ON/OFF: Press ENT
button to enter the main menu, press ENT again while
"SYSTEM" is flashing. Use UP and DN until flashing
"BUZZE" is displayed and press ENT. When "STATE"
is shown, press R or L to toggle between ON and OFF
settings. Press ENT to confirm and EXT to exit.
(2) [SYSTEM/BUZZE/THSTK] Throttle stick: under the Buzzer
setting menu the option THSTK can be set to ON or
OFF. If the Throttle Stick setting is ON/Active, a musical scale will be heard when moving the throttle stick.
The position of the throttle stick can be judged by listening to the change in musical tone. Setting OFF, turns
off the sounds. After setting the [BUZZE\STATE] setting, press DN until THSTK is displayed. The current
status is displayed, use R or L to change the display between INH and ACT. ACT means tones will be played,
INH means there will be no tones played.
(3) [SYSTEM/BUZZE/TONE] Buzzer tone: the buzzer tone can be selected from 10 notes. You can set the
tone according to your preference. After setting the "THSTK", press DN until "TONE" is displayed. Use
R or L key to change the flashing value between 1 and 10.Press EXT button to exit when finished.
1.4 Vibrator Setup
The DEVO 7E can set Vibrator as an alarm function.
Setup: Press ENT to the Main Menu, use UP or DN to select System Menu. And then press ENT to get the
System Menu, use UP or DN to select Vibrator. Press ENT to get Vibrator setup interface. There are Inhibit
and Active two status. Press R or L to select Active for Vibrator function. Press EXT to exit after finished.
Buzzer
St at u
Thro tP
1.5 Stick Mode Setup
There are 4 stick modes including MODE1, MODE2, MODE3 and MODE4. Right-hand throttle includes MODE1
and MODE3; while left-hand throttle includes MODE2 and MODE4. See below setup:
[SYSTEM/STMOD] Stick Mode: from the SYSTEM menu, press UP or DN until flashing "STMOD" is displayed,
press ENT again to enter the stick mode selection sub-menu. Use R or L to select the required stick mode.
Press ENT to confirm the flashing value and EXT to exit to the main menu.
Sti c Mode
Stic
o d e
NAode 1
tylode 2
- „
o d e 4
[S t i c k. M
ID
d
e
Mode 1
VMOdeH2
Mode 3
Mode 4
Stic k. l'...d o d
NA odP I
Mode 2
t.y1 0 d
e :::
'Mode 4
Please refer to 8.0 Switches exchange between left-hand and right-hand throttles.
Press EXT to exit after finished.
DEVO 7E- 1 5
Advertisement
Table of Contents
