Table of Contents
Advertisement
Off
cleUention
DEVO 7E
Welcome to use the DEVO 7E transmitter
10.0 Customized fixed ID
Using the Fixed ID function allows users to create a unique relationship between transmitter model data and
the corresponding model's receiver. It significantly speeds up the binding process and also prevents mistakenly
flying an aircraft with the incorrect transmitter model selected.
(1) Fixed ID setup
To start the Fixed ID setup it is important that the transmitter and receiver have successfully completed automatic
ID binding process. Once the transmitter and receiver are paired a Fixed ID can be set as described below.
Press the "ENT" button on the main panel and a flashing System will display in the LCD. Use UP or DN to
cycle through the options until Model menu appears flashing. Press "ENT" again to enter into Model edit menu.
Press UP or DN until a flashing "FIXID" is displayed, press "ENT" to enter the Fixed ID menu. The current
status is displayed. Use R or L to toggle between modes and set to "ON". Press DN to confirm and enter the
Fixed ID code setting screen.
Fi xe d ID
:3 t at u s
Press ENT to change the code data, use R and L to change
the code values, press DN to move to the next digit, UP to
move to the previous digit. There are 6digits can be settled.
Fi xe d ID
3 tat u s
C:: 0
dP
F F
j
Fi xe d ICI
t atu s
0 n
ID Code
--' 1"p
,
After setting the desired code press ENT, "RUN" will be displayed. Use R or L to change NO to YES and
press ENT to confirm and execute the binding process. An inquiry interface of "Are you sure?" pop up. "ID
Code Matching ... ..." will be shown after press ENT. After binding the display will return to the model menu
automatically.
Fi xe d 1E)
ID
ID NA at° h
1E
Fi Nd 1 D
Are s.iou sure?
IC
(2) Cancelling/Resetting the Fixed ID
If you wish to change the receiver Fixed ID model back to random ID, insert the included BIND PLUG into
the output terminal BATT before the receiver is powered on. Connect 5V DC power to the Throttle channel.
The red LED of the receiver will flash slowly. Remove the BIND PLUG. The Fixed ID code has been cancelled.
After the receiver's Fixed ID is reset it should also be reset in the Transmitter. Here is the setup:
In the main interface press the ENT to enter Model
Menu and then press UP or DN to move the navigational
mark to select MODEL MENU. Press ENT to enter
MODEL MENU. Press UP or DN to select Fixed ID code
and press ENT key to enter the Fixed ID code interface.
Press UP or DN to select STATUS option, Press R or
L to change the status to Off. Then press EXT to exit.
DEVO 7E -10
Advertisement
Table of Contents
