Table of Contents
Advertisement
P ro g ram M ,:; 1
F' 0 s
p
Program Mi>:: 1
Offset
Or .:%;
Throttle
Inhibit
F'rogram NA
i
1
Throttle
Roz
t-1
F' 0 s
Program N ii::; 1
ThrottlID
C
_~
Witl= h
11
P o s 0
ri
ht o
d
e
05)Flight Mode
@Flap
No rrn al
F'ro y ram
i 1
Nil a ste r
Elevator
e %,;:kt 0 r.
L
L I 21113 Fl
Welcome to use the DEVO 7E transmitter
cleUention
DEVO 7E
(1.3) Gain setting:take Elevator at Master Channel as an example.
(1.3.1) Position 0 upward
Mix amount setting when elevator stick moved upward.Press
UP or DN to make the navigation mark choose "position 0
upward"item,and press R or L can increase\decrease Mix
amount.lt is possible to reverse mix direction through
changing the plus or minus sign before amount.The
adjustable range is ±125%.
(1.3.2) Position 0 downward
Mix amount setting when elevator stick moved downward. Press UP or DN to make the navigation mark
choose "position 0 downward" item, and press R or L can increase \decrease Mix amount.lt is possible to
reverse mix direction through changing the plus or minus sign before amount.The adjustable range is ±125%
(1.3.3) Position one upward/downward setting method refer to (1.3.1) position zero upward setting .
(1.3.4) Offset Setup
This function can make Slave begin to mix through the
corresponding Lever switch from a certain point as the starting
Offs et
point. Press UP or DN to make the navigation mark choose
"Offser',press R\L to increase or decrease the mix amount.lt is
possible to reverse the offset direction through changing the plus
or minus sign before amount. The adjustable range is ±100%.
(1.4) Throtte Stick
Press "UP" or "DN" to select "throttle stick setting".Press "R"or "L" to change the data for setting its position
amunt or Inhibit. The default setting is Inhibit. The adjustable range is 0.0-100.0%.
ro g
rain Mix 1
Throttle Stick.
ill
;
1...! I.
(1.5) Switch Selection
Press UP or DN to make navigation mark select "switch" setting, prss ENT enter into useable switch interface,
press UP or DN to make navigation mark select desired switch setting.Press ENT to confirm,make left sign
from "0" to "1". If two or more items are selectable,the item And should be selected, to make left sign from
"0" to "1", Press EXT to exit after finished.
(2) Setting Method for Curve in Program Mixl
Press the item Curve in Program Mix 1 and expands an enquiry All Servos Hold?" Click OK for all the servos
will be locked at the current states; click Cancel for unlocked. Enter the next interface after clicking. Press ENT
key to enter the setting interface of Program Mix1. The interface will show the setting items and curve table.
F' ro g r am NA i 1
All 517..!rly'os Hold
an e
'=====.2=nx.mauxesustms=me:=3
DEVO 7E -
65
Advertisement
Table of Contents
