Table of Contents
Advertisement
Right throttle set
Left throttle set
Throttle Control
Spring
—Screw G
Screw F
I CIPLIerAjOil
00 e 00
CI MI
ij
Q16 Eli
110 D 1
Connection icon at
trainee's DEVO 7E
deention
DEVO 7E
Welcome to use the DEVO 7E transmitter
8.2 Left-hand throttle switched to right-hand throttle
(1) Mechanical Step
Refer to the above(8.1) "Mechanical switch" to remove the transmitter cover.
Remove the 6 screws and rear cover to expose the base plate. The photo below shows the internal views of
right and left hand throttle setups. Using a cross-head screwdriver loosen and remove, in order, the Linkage
Fixed Screw, Screw F, Screw G and the Throttle Control Spring from the right throttle set, remount the parts
removed into the left throttle set in the corresponding (rotated) positions shown below. Adjust the tension
using Screw F to match your preferred setting. Replace the rear cover.
Linkage Fixed Screw Screw F
Screw G Linkage Fixed Screw
(2) The ELECTRONIC Step
From the Main Front Panel, press "ENT" button, in the LCD screen, "System" will start to flash. Press the
"ENT" button again to enter the System Menu. Use the UP and DN buttons until flashing "STMOD" appears,
press "ENT" to enter Stick Mode Selection Menu. Use UP or DN buttons until flashing "MODE 1" or "MODE
3" appears. Press "ENT" to confirm and "EXT" button to return to operation mode.
All saved model data will automatically be switched to be compatible with MODE
1
or MODE 3.
Sti c
o d e
Miganti
mode
2
Mode 3
_ mode
4
1:4-41Frl
.
E
•
3 ti k Mode
Model
Mode 2
Mode 3
f4p::1 1'4E')
Mode 4
Once both the MECHANICAL and ELECTRONIC steps are successfully completed the transmitter is now
ready for normal operation.
Note: Pay careful attention to the force used when removing, replacing and adjusting the screws. Excessive
force may damage them or the base plate.
9.0 Training function
Two DEVO 7E transmitters can be made to work together in order to offer a teachertrainer function, meeting
the requirements for a beginner. The setup of training mode is described below :
(1) Model data transmission
First step is to use the DEVO 7E's wireless data transmission feature to transfer the teacher's main model
data to the trainee's DEVO 7E transmitter. This step guarantees that the model data in each transmitter is
identical. Refer to item "2.4 model wireless copy" in the Helicopter section later in this manual. Two DEVO
7E transmitters are needed for wireless data transmission.
(2) Training connection
Insert one end of the signal wire (included) into the DSC
socket of the trainee's transmitter and turn it on. PC 0% will
be shown in the trainee's DEVO 7E display (see image right).
DEVO 7E —8
Advertisement
Table of Contents
