devention DEVO 7E User Manual page 72

I~r
An ion
I II I
Trainee is working and trainer is off
1.1
"7.5.
Trainer
Eleiyiator .
1111EMIM
Aileron
E ibit
Timer
Type
Stopwatch
Welcome to use the DEVO 7E transmitter
cleUention
DEVO 7E
Linkage Display
Next, tum on the Trainer's DEVO 7E. Select the newly copied model data using the MODEL Menu. Bind to
the aircraft and make a small test flight to confirm the aircraft is operating normally. Tum off the power andinsert
the digital signal wire into the trainer's DEVO 7E DSC port. Tuming back on the power will automatically put
the DEVO 7E into training mode.
r
in Trainee is off and trainer is working
I
1
ry 7"-+:7,-
•
Trainer icon
Training Status Display: when the trainer's icon turns to "X", the trainee stops flying and the trainer is working;
when the trainer's icon turns to"V", the trainee is flying and the trainer is in leisure.
(3) Usage
The default setting of the training switch is "R+" key.
During flight, if the trainer press" R+"key,the linkage icon will
be shown as "- N i" that means the control right is moved to the
trainee from trainer. If trainer pushes "R+" key once again,
the linkage icon will be show as "X" that means the trainer
takes back the control right from the trainee.
(4) Setting for training function channels
Trainee is available to get full or part of flight control power to the aircraft model via setting the training function
channel in the trainer's radio. Below is the Setup:
Press the ENT to Main Menu, use UP or DN to Function Menu. Use UP or DN to select Trainer and press
ENT to enter Trainer interface. The available channels are shown between Elevator, Aileron, Throttle, Rudder,
Gear, Pitch and Gyro, and the current status of trainer switch is also shown there.
Channel selection:
Press UP or DN to select the channel option; press R or L
to select the channel(s) which you want to grant to trainee.
The channels(s) you have selected will be activated as
"Active". The channel(s) which are not granted to trainee
will be kept inhibited. The default setting is "Inhibit".
Press EXT to exit.
3.17 Timer
There are two timers on the DEVO 7E, stopwatch and countdown
timer. These timers are activated by switch or by shorcut.
Setup:
Press ENT to Main Menu, use UP or DN to Function Menu.
Press ENT to enter Function Menu. Use UP or DN to choose
Timer, and press ENT to enter Timer setting interface. The
factory default is Stopwatch, and the timing range of stopwatch
is from 0 to 60.
DEVO 7E-
69