Table of Contents
Advertisement
Voltage
Inhibit
Inhibit
Inhibit
am
Volta.g e
5.3 Unit
8,3 Unit
a o
ri
it
Rate :- - 2 ,ensor
Inhibit
Inhibit
CIE
Rate Sensor
5 000
FIP
NA
4 000 A P
0
5":2 thi
Nl
i:DC1
1
Connection icon at
trainee's DEVO 7E
it
deVention
DEVO 7E
Welcome to use the DEVO 7E transmitter
(1) Voltage:Provide 3 diffferent measured voltage values;
(2) Temperature:Press UP or DN to Temperature, which provides 4 different measured temperature values;
Temperature
Inhibit
Inhibit
Inhibit
Inhibit
Te
'
m
p
ore,
rature
'2
L
1
°C:
21 °C::
D
(3) Rate Sensor:Press UP or DN to Rate Sensor, which provide 2 different measured RPM values;
(4) GPS Sensor:Press UP or DN to turn to GPS Sensor, show located date, time, longitude, latitude, altitude
and speed;
GF'3 Sensor
Inhibit
Inhibit
Inhibit
Inhibit
3.20 Trainer
To help the beginner pilot it is possible to make two DEVO 7E transmitters operate together using a training
function. The training function permits the teacher to limit or override the controls of the trainee. The instructions
for using the training function are below:
(1) Data copy
The first step is to copy the model settings from the teacher's DEVO 7E to the trainee's DEVO 7E, this guarantees
that the model data in both transmitters is identical. To do this refer to the copy method as described in Helicopter
setup section "2.4 model wireless copy". Once completed, follow the steps below:
( 2) Connection
Insert the signal wire (supplied) into the DSC socket of the
trainee's transmitter.Turn on the trainee's transmitter and the
display will alternate between showing PC (data connection
mode) and the model name (MOD), see image (right)from
the trainer's transmitter into the DSC socket of the trainee's
transmitter. Turn on the transmitter and a linkage icon will be
shown on the boot screen.
DEVO 7E-
68
Advertisement
Table of Contents
