Table of Contents
Advertisement
D e e 0
Lb ut
G e ar
HOLD 3W
Fun cti o n
Act
i'y'
e
D N wj C
utp ut
Gear
HOLD
Functio
Welcome to use the DEVO 7E transmitter
cleUention
DEVO 7E
(1) Gear
Press UP or DN in output interface can change the GEAR Switch. It includes FMOD SW, HOLD SW, SPSO SW,
SPS1 SW, SPS2 SW, SPS3 SW. Press R or L to select the setting switch, The default setting is HOLD SW.
Press UP or DN to select Function Setting after you select the switch,Press R or L can enter the interface of Gear
activate, inhibit, Gyro and Govemor. The default setting is Activate. You can continue to set other items after finishing.
(2) AUX 2
Press UP or DN to enter the AUX2 interface.Press R or L can change the AUX2 switch. It includes FMOD
SW, HOLD SW, SPSO SW, SPS1 SW, SPS2 SW, SPS3 SW. The default setting is FMOD switch.
Press UP or DN to select the Function Setting, press R or L to choose the switch, it inculdes Inhibit, Active,
Gyro, Governor. The default setting is Gyro.
r
Device Output
A U :>:2
De vi c e utp ut
Al X2
Ft
r)E)
Fu n ct 0 11
ti 1. . . 1
After finishing the setting, press EXT to exit.
2.11 Swash Type
The Swash Type menu features five options:
1
Servo Normal, 2 Servos 180°, 3 Servos 120°, 3 Servos 140°
and 3 Servos 90°.
Setup: Press "ENT" to enter Main Menu, press UP or DN until "MODEL" flash , and then press "ENT" to enter
Model Menu; Press UP or DN to choose "SWASH" press ENT enter to Swash setting interface.
I I
I ::11-
Press UP or DN to choose the required swashplate type.
Press ENT to confirm, the corresponding items will have
the "V" mark in front of the items.Press EXT to exit after
finishing.
SPryo 1 2 Cr
3 Servo E . ; 1 4 Cr
2.12 Fixed ID
Using the Fixed ID function allows users to create a unique relationship between transmitter model data and
the corresponding model's receiver. It significantly speeds up the binding process and also prevents mistakenly
flying an aircraft with the incorrect transmitter model selected.
(1) Fixed ID setup
To start the Fixed ID setup it is important that the transmitter and receiver have successfully completed automatic
ID binding process. Once the transmitter and receiver are paired a Fixed ID can be set as described below.
Press the "ENT" button on the main panel and a flashing System will display in the LCD. Use UP or DN to
cycle through the options until Model menu appears flashing. Press "ENT" again to enter into Model edit menu.
Press UP or DN until a flashing "FIXID" is displayed, press "ENT" to enter the Fixed ID menu. The current
status is displayed. Use R or L to toggle between modes and set to "ON". Press DN to confirm and enter the
Fixed ID code setting screen.
DEVO 7E -
21
Advertisement
Table of Contents
