Table of Contents
Advertisement
;tic k. P o s it ion 3w„,
gention
DEVO 7E
Welcome to use the DEVO 7E transmitter
Press UP or DN to inhibit channel in navigation mark, and press R to expand the menu.The channel includes
four items: Elevator, Aileron, Throttle and Rudder. The factory default is Inhibit. Take Elevator for example.
Press R or L to choose the Elevator as stick, then Press DN to move nagivation mark to value of position.
It's possible to adjust the stick position via pressing R or L.
Stick. Position 3 %.A.°
W I
tr h
Position
1_I
Vy'
Channel
n
Elevator
Press DN to navigate the OPEN setting, press R or L to change the direction of the channel stick.
Press UP or DN to navigate the STATUS, which can check the sketch map of the stick OPEN/CLOSE direction.
Check if it was set correctly.
r
dw.
u !Hui
Position
0 n
Up
.
.....
-
110i::. I-) OS iti 0 11 ;',;,r
g
3 t l.t
ij
On
l If
After finished the setting, press EXT to exit.
2.9 Device select
This setting allows customization of the various function switches. The switches Flight Mode (top right comer) and
Throttle Hold (top left corner) can accept custom settings. Stunt Trim mode can also be defined under this sub-menu.
Setup:
Press ENT to enter Main Menu, press UP or DN to move navigation mark to select Model menu. Press ENT
to enter Model menu function. Press UP or DN to select Device Option. Press ENT to Device Option interface.
(1) Flight Mode Switch:Press UP or DN to move navigation
mark to Flight Switch and press R or L to select the
Flight 3i
desired switch,there are both FMOD SW and HOLD
SW,. The factory default setting is FMOD switch.
(2) Stunt Trim Mode: There are two option modes, Common
:::;tu nt Tr; RI
and Flight Mode. In Common Mode, all the trim values
settings are applied the same to each Flight Mode. In
Flight Mode, the trim value can be set and remembered
differently for each of the 3 available Flight Modes. The default is common.
Setup:
Press UP or DN to choose the Stunt trim select, press R or L to select "Common"or Flight Mode, the factory
default setting is Common.
(3) Throttle Hold Switch: Refer to "(1) Flight Mode switch"
After finishing the setting, press EXT to exit.
2.10 Device Output
Device output can set up the output switches respectively. It can also activate, inhibit or use other functions.
Setup:
Press ENT to enter main menu, press UP or DN to move
navigation mark to Model Menu. Press ENT to enter Model
Menu. Press UP or DN to select Output Device and press
ENT to enter Output Device interface.
.
_
R 0
1_0 IJt
G ar
HOLD SW
Fu rti 0 n
There are 2 settings:Gear, AUX2.
t i
D e
ehE ct
C 0 111 m 0 n
DEVO 7E
-
20
Advertisement
Table of Contents
