devention DEVO 7E User Manual page 54

Voltage
Internet 5'v'
Inhibit
'Volt .g e
I rite rn al:
ariTi \loitage
3,6 Unit
VO
a9 P
E rn
:
-3RI:Qiaaii iii
',/ci It 8.9
a 2 Unit
~TeIiiperature
p I
T1
Inhibit
Terilpii::l :
1 Lirre 3ni2.1
C:e Is i Lis
.
~ 1
i .
Actiiy'e
Alarm
T2 Inhibit
100 c.1
Welcome to use the DEVO 7E transmitter
cleention
DEVO 7E
Press UP or DN to select the Alarm Voltage setting, press R or L to set the value. The range is 3.6-6V. you
can continue to set other items after you finished.
(2.2) External V1
Press UP or DN enter to External V1 setting interface. Press R or L to activate the V1, the details refers to
the Illustration.
'tag P
E•gte rn al:
Ac:tivf-
Press UP or DN to select the Alarm Voltage setting. Press R or L to set the value. The setting range is
0.2-99.9V. You can continue to set other items after you finished.
(2.3) External: V2 setting can refer to External V1 setting.
Press EXT back to sensor setting interface after you finished.
(3) Temperature sensor
The temperature sensor can measure up to 4 different temperature(i.e.motors).You can choose Celsius or
Fahrenheit.The alarmed value can be setted to 4 different temperature.Once the measured value is higher
than the setting value,the radio will alarm.The Alarm Temperature value can be setted as -20-220t or
-4.0-428.0° F.
Temperature Setup:
In the "Sensor Setting"interface,press UP or DN to make the
navigation mark to choose "Temperature Sensor", and press
ENT to enter "Temperature Sensor" setting interface. See
the illustration.
(3.1) Unit
Press UP or DN to make the navigation mark to choose "Unit" setting item, and press R or L to choose Unit,
two kinds of Unit:Celsius and Fahrenheit.
(3.2) Alarm Temperature Setup
Press UP or DN select the T1, Press R or L to activate the
setting.lnhibit will change to Active and Alarm temperature
will be shown. If you choose Inhibit, the Alarm temperature
value won't be shown.
Press UP or DN to select "Alarm" setting, press R or L to
set the alarm temperature value. Press UP or DN to set
other items after finishing the setting.
F' Setting
Altitude Ts.ipe
$olute
PRI:!d j I1
(3.3) T2, T3, T4 Setup
Refer to the step of "(3.2)T1".
(4) GPS Setup
There are 4 items including Altitude Type,Speed Unit, Date
Type and Time Zone in the GPS receiver setting interface.
Press UP or DN to select the Sensor setting interface
to enter the GPS setting interface.
DEVO 7E-
51