devention DEVO 7E User Manual page 33

Giyiro ::pnsor .
.
. z . i t at u
1`..1 o rrn e.1
Norm al
Nlode
o rn o r
t atu
Channel
6,U
ociXention
DEVO 7E
Welcome to use the DEVO 7E transmitter
(1.4.2) The POS 1 setup is the same as above POS 0.
(2) Automatic setting
r
(2.1) Automatic Setup
In the Gyro Sensor interface, press UP or DN to choose
Mode, there are Manual set and Automatic set for
selectable choice. Press R or L to select Automatic option.
M o d e
Auto rnatic
Channel
(2.2) Channel
V.
I I ',.")
The factory default channel is AUX2, the Output set offer the function to change other control channels (Refer
to "2.10 Output").
(2.3) Switch Select :No use in Automatic Setting.
(2.4) Status
Tum the Flight mode Switch or Throttle hold Switch,the status set will display the current flight mode position.There
are Normal Mode, Stunt Mode and Throttle hold available. The Throttle hold need to activate
to use.( Refer to "3.5 throttle hold")
(2.4.1) Normal Mode
Press UP or DN to Normal Mode,press ENT to Normal mode.
Use R or L to set the value individually. The GYRO has two
modes of operation; AVCS or NOR. When the value is set
less than 50% it is NOR mode. the smaller the value is, the
greater of the GYRO sensor rate gain becomes,or the harder
it tries to maintain a constant YAW rate. The factory default
value is 50%.
(2.4.2) Stunt Mode and Throttle hold setup refer to Normal Mode.
After finished the setting, press EXT to exit.
Notes: The Gyro sensitivity setting just can be set when there is a gyro menu listed in Output in Mode Menu.(Refer
to "2.10 output")
3.9 Governor
To setup Governor, the Governor needs to be active under the Device Output menu (Refer to section 2.10
Device Output).
The Governor function is a feature which, when enabled, automatically tries to maintain a constant main rotor
speed. It is possible to setup different Governor settings for each flight mode. On the transmitter, the display
is apercentage for reference/adjustment, the actual rotation speed is set by the governor.
Setup:
Press ENT to Main menu in the interface, use UP or DN to
choose function menu. Press ENT to function menu. Use UP
or DN to choose Govemor, then press ENT to the Govemor
setting interface, there are status and channels. Press UP or
DN to the Normal Mode, Stunt Mode or Throttle Hold.
(1) Status
Toggle the Flight Mode or Thottle Stick Lock switch, the status display present flight mode position.There
are Normal Mode, Stunt Mode and Throttle Hold. Throttle hold need to activate.(Refer to 3.5 throttle hold)
(2) Channel: Setup refer to 2.10 Output
( 3) Normal Mode
Press UP or DN to choose Normal Mode, press R or L to
increase or decrease the value. The factory default value is 0%.
(4) Stunt Mode and Throttle Hold setup refer to Normal
Mode(3)
After finished, press EXT to exit.
G o ye rn o r
NJ o r m 3.1 NA 1. - J
Stunt Mode
DEVO 7E - 30