Table of Contents
Advertisement
Rudder tn Ailercirk
Elevato r Po :7-; 0 Le<t
0%
Pos U Right
h
(0) r g
ht mode
0
(15:1 Fl i 9 h t NA 0 d e
(5)Flap Normal
Flap stem
0: N o rm al
1: Ldnd
cleention
DEVO 7E
Welcome to use the DEVO 7E transmitter
3.13 Rudder to aileron/elevator mix
This function is used to execute the mix of rudder to aileron/elevator. It will help eliminate waver or shake
caused by rudder stick operation.
Setup:
Press ENT to enter Main Menu in the main interface,and
press UP or DN to make the navigation mark to choose
"Function Menu". Press ENT to enter "Function Menu", then
press UP or DN to choose "Rudder to aileron/elevator mix"
and press ENT to enter "Rudder to aileron/elevator mix"
setting interface.
(1) Elevator setup
(1.1) Elevator Pos 0 Leftward Setup
Press UP or DN to make the navigation mark choose "Elevator Pos 0 Leftward setting" item, and press R or
L to change the value and the Elevator mix amount when operating Rudder leftward. The mix direction will
be revised by changing the sign of plus or minus before the value. The adjustable range is ±125%.
(1.2) Elevator Pos 0 Rightward Setup
Press UP or DN to make the navigation mark choose "Elevator Pos 0 Rightward setting" item, and press R
or L to change the value and the Elevator mix amount when operating Rudder rightward. The mix direction
will be revised by changing the sign of plus or minus before the value.The adjustable range is ±125%.
(1.3) Elevator Pos 1 Setup:refer to "1.1 Elevator Pos 0" Setup.
(2) Aileron Setup
(2.1) Pos 0 Setup: refer to "1.1 Elevator Pos 0" Setup.
(2.2) Pos 1 Setup: refer to "1.1 Elevator Pos 0" Setup.
(3) Throttle stick setup
The switch between Pos 0 and Pos 1 can be realized by the position of Throttle Stick,then press R or L to
change the value or Inhibit. Change the value to set the Thottle Stick position. The default setting is "Inhibit",
the adjustable range is from 0.0 to 100.0%.
(4) Switch Setup
Switch item will display the current Switch position.Press UP or DN to make the navigation mark choose
"Switch" item, and ENT to enter the selectable switch interface, press UP or DN to make the navigation mark
choose the desired Switch. Press ENT to confirm and change the left sign from "0" into "1". If two or more
items are selected, the item And should be selected and then the left sign "0" will be changed into "1". Press
EXT to exit after finished.
R
1=! r to Ai leron...
Th
e Sti
Inhib it
h
Pos 0
3.14 Flap System
This function can modify some effects on elevator.lt is possible to set 2 status of elevator through 2-way flap
control switch.
Setup:press ENT to enter Main Menu in the main interface,
then press UP or DN to make the navigation mark choose
"Function Menu", press ENT to enter Function Menu. Press
UP or DN to choose "Flap System" and then ENT to enter
its setting interface.
(1) Elevator Setup
There are 2 options: 0:Normal and 1:Land.
DEVO 7E-
62
Advertisement
Table of Contents
