Table of Contents
Advertisement
Governor .
Status
Governor
Flight Mode
0%
cleUention
DEVO 7E
Welcome to use the DEVO 7E transmitter
(2.4) Status:turn the Flight Mode switch,the status display current flight mode position.There are "Flight Mode
0", "Flight Mode 1" etc.
(2.5) Flight Mode 0: Press UP or DN to select Flight Mode
0, press R/L can increase or decrease the value individually.
If the gyro used has two modes of NOR and AVCS, NOR
will be activated when the value is less than 50.0%. In NOR
mode, the smaller the value is, the bigger the gyro sensor
gain will be. The factory setting is 50.0%.
G I!. . ..iro Sens or
Sta.tu!E;
Flight Mode 0
tylode 0
50.0
(2.6) Flight Mode 1 setting refer to "Flight Mode 0".After finishing the set, press EXT to exit.
3.10 Governor
To setup Governor, the Governor needs to be active under the Device Output menu (Refer to section 2.10
Device Output). The Govemor function is a feature which, when enabled, automatically tries to maintain a
constant main rotor speed.
It is possible to setup different Governor settings for each flight mode. On the transmitter, the display is a
percentage for reference/adjustment, the actual rotation speed is set by the governor.
Setup:
Press ENT to Main menu in the interface, use UP or DN to
choose function menu. Press ENT to function menu. Use
UP or DN to choose Governor, then press ENT to the Governor
setting interface, there are status and channels. Press UP
or DN to "Flight Mode 0", "Flight Mode 1", and so on.
Chan n P
(1) Status
Toggle the Flight Mode, the status set display present flight mode position. There are "Flight Mode 0", "Flight
Mode 1" and so on.
(2) Channel: The setted channels will display in "2.10 Device output" (Setup refer to 2.10 Device Output)
(3) Flight Mode 0
Press "UP/DN" to make the navigation choose the "Flight
Mode 0"set, press R/L to increase/decrease the value.The
factory default value is 0%.,adjustable range ± 125%.
(4) "Flight Mode 1" setting refer to "Flight Mode 0".
After finished, press EXT to exit.
3.11 Aileron to Rudder Mix
This function is possible to execute the mix of aileron to rudder, which is controlled by switch.
Setting method:
Press ENT enter to Main menu, press UP or DN to select Function menu. Press ENT enter to Function menu.
Press UP or DN select Aileron to rudder mix,press ENT to enter into Aileron to Rudder mix setting interface.
Aileron to Rudder... CI
Pos . 0 Left
(1) Pos 0 Setting leftward setup
Press UP or DN select leftward mix value, press R or L,
leftward mix value of aileron to rudder will be changed.
The mix direction will be revised by changing the sign of
plus or minus before the value. The adjustable range is
±125%.
09;
Pips 0 Right
(2) Pos 0 Setting rightward setup
Press UP or DN to select rightward mix value, press R or L rightward mix value of aileron to rudder will be
changed. The mix direction will be revised by changing the sign of plus or minus before the value. The
adjustable range is ±125%.
DEVO 7E -
60
Advertisement
Table of Contents
