Table of Contents
Advertisement
477
Press R or L to select Activate or Inhibit (the default setting
is Inhibit), such as press Activate will includes No Signal
Waming, Voltage sensor, Temperature sensor, GPS receiver
setting etc.
clAntion
DEVO 7E
Welcome to use the DEVO 7E transmitter
Fired I D
Statu
Ir I c 0 d
p
On
0 J 1 0 0
ij ij
Fi xe d I D
St atu s
Off
Press ENT to change the code data, use R and L to change
the code values, press DN to move to the next digit, UP to
move to the previous digit. There are 6digits can be settled.
After setting the desired code press ENT, "RUN" will be
displayed. Use R or L to change NO to YES and press ENT
I D I.. 0 CI
e
to confirm and execute the binding process. An inquiry
interface of Are you sure?" pop up. "ID Code Matching ...
..." will be shown after press ENT. After binding the display will return to the model menu automatically
Fixed ID
Fixed ID
p.tu
••
I
!
1:1 ;RI
h
Fig'...::
.
I
I ID
Are vou
(2) Cancelling/Resetting the Fixed ID
If you wish to change the receiver Fixed ID model back to random ID, insert the included BIND PLUG into
the output terminal BATT before the receiver is powered on. Connect 5V DC power to the Throttle channel.
The red LED of the receiver will flash slowly. Remove the BIND PLUG. The Fixed ID code has been cancelled.
After the receiver's Fixed ID is reset it should also be reset in the Transmitter. Here is the setup:
In the main interface press the ENT to enter Model
Menu and then press UP or DN to move the navigational
mark to select MODEL MENU. Press ENT to enter
MODEL MENU. Press UP or DN to select Fixed ID code
and press ENT key to enter the Fixed ID code interface.
Press UP or DN to select STATUS option, Press R or
L to change the status to Off. Then press EXT to exit.
2.13
Sensor Setup
Press ENT enter to the Main Menu. Press UP or DN to select the Model Menu. Press ENT enter to Model
Menu. Press UP or DN to select sensor press ENT enter to the sensor setting interface. See the Illustration.
Pnsor vetting
Sensor St at u
(1) No Signal Warning
Press UP or DN to make the navigation mark to choose "No
Signal Warning". Press R or L to choose "Inhibit" or "Active"
(default setting is" inhibit"). If you choose "Active", the Radio
will alarm when telemetry signal lost. As following:
Sensor Setting
Cri b
:-; 11 . ! n :.:.; or St at u s
.6 ,1:: ti v
P
I'd o :z.; i g n a.I
Iii i n !::::1
1
Mininiiiiiig 1
DEVO 7E —
22
Advertisement
Table of Contents
