Manually setting TCP/IP Addresses
At the WorkCentre 4118, perform these steps:
HINT:
WorkCentre 4118, refer to the Internet Services chapter for instructions.
When manually making the TCP/IP settings, you will need to know the following information:
The IP address.
The subnet mask, if required.
The Gateway address, if required
The primary and Secondary DNS address, if required.
Ensure the Ethernet Port has been configured (see "Ethernet Port" on page 2-3).
1
Press the [Machine Status] button.
2
3
Press
Admin Tools displays and press
[Enter].
If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
4
Press
Setup displays and press [Enter].
Xerox WorkCentre 4118 System Administration Guide
Xerox CentreWare Internet Services can also be used to configure the
or
until System
or
until Network
System Admin Tools
[Passcode Protect]
System Admin Tools
[Network Setup]
Page 2-9