Motor Holding Brake - Siemens SINAMICS G120C Operating Instructions Manual

The converter evaluates its control commands depending on digital input DI 3:
• Via a fieldbus from a central control system
• Via the converter digital inputs at the installation.
Note
The converter requires approx. 4 ms to switch over the command data set.
Parameters
Number
p0010
r0050
p0170
p0809[0 ... 2]
p0810
p0811
8.13

Motor holding brake

Overview
The motor holding brake holds the motor in position when it is switched off.
When the "Motor holding brake" function is correctly set, the motor remains switched on as
long as the motor holding brake is open. The converter only switches the motor off when the
motor holding brake is closed.
SINAMICS G120C Converters
Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK
Name
Drive commissioning parameter filter
CO/BO: Command data set CDS effective
Number of command data sets (CDS)
Copy command data set CDS
BI: Command data set selection CDS bit 0
BI: Command data set selection CDS bit 1
Advanced commissioning
8.13 Motor holding brake
Factory setting
1
-
2
0
Dependent on the
converter
0
245