Print Server Correction - Canon imagePRESS C7000VP Reference Manual

IMPORTANT
Only 330.2 mm x 482.6 mm, 320 mm x 450 mm (SRA3), 304.8 mm x
457.2 mm, 11" x 17", A3, A4, or LTR plain paper can be used for test prints.
Make sure that a sufficient supply of paper is loaded into the machine
before starting this procedure.
5
View the output test print ➞ press [Fine Adjust] of the
colour you want to adjust.
6
Select the number to adjust ➞ press [+] for the heavy
density or [-] for the light density ➞ [OK].
NOTE
The colour patterns on the test print are laid out in numeric order (-6 to 6)
when the cyan patterns are on top. The patterns under -6 and 6 may not be
shown, depending on the paper width. In this case, the numbers are from -5
to 5.
7
Press [Store and Finish].
The display returns to the screen of step 2. Repeat these steps until
the shading is improved.
NOTE
If [Test Print] is pressed before pressing [Store and Finish], a test print with
colour patterns after adjustment is output.

Print Server Correction

NOTE
Operations on the print server side are required. For more information on
the procedure, see the instruction manual of imagePRESS Server.
1
➞ [Adjustment/Cleaning] ➞ [Shading Correction].
Press
2
Press [Print Server Correction].
3
Press [Test Print].
Test print is output.
IMPORTANT
Only 330.2 mm x 482.6 mm, 320 mm x 450 mm (SRA3), 304.8 mm x
457.2 mm, 11" x 17", A3, A4, or LTR plain paper can be used for test prints.
Make sure that a sufficient supply of paper is loaded into the machine
before starting this procedure.
4
The printer server is forwarding the adjustment values.
Please wait until the transmission is complete.
5
Press [Store and Finish].
The display returns to the screen of step 2.
Adjusting the Machine A4-66