● If you select [On]:
❑ Select [On] or [Off] for <Use SSL> ➞ press [OK].
Use SSL (Secure Sockets Layer)
[On]: SSL is used to communicate.
[Off]: SSL is not used to communicate.
● If you select [Off]:
❑ Press [OK].
NOTE
• Before setting <Use SSL> to 'On', it is necessary to set a default key in
Network Settings (from the Additional Functions screen). (See Chapter 3,
"Using a TCP/IP Network," in the Network Guide.)
• The Use HTTP mode is enabled only after you restart the machine (the
main power is turned OFF, and then back ON). For instruction on restarting
(turning the main power OFF, and then back ON) the machine, see "Main
Power and Control Panel Power," on p. A1-7.
• Any changes made to <Use SSL> are also applied to <Use SSL> in
Remote UI in System Settings (from the Additional Functions screen).
Printing Installed Application Information
You can print the MEAP application information, as well as certain
system application information.
NOTE
The information is printed as a report.
1
➞ [System Settings] ➞ [MEAP Settings] ➞ [Print
Press
System Information].
2
Press [Yes].
MEAP Settings
A6-30