Canon imagePRESS C7000VP Reference Manual page 83

• To print on the back side of preprinted paper, load the paper into the stack
bypass, and press [2nd Side of 2-Sided Page] on the paper selection
screen that appears.
• When printing on special types of paper, such as heavy paper or
transparencies, be sure to correctly set the paper type, especially if you are
using heavy paper. If the type of paper is not set correctly, it could adversely
affect the quality of the image. Moreover, the fixing unit may become dirty
and require a service repair, or the paper could jam.
• If you select [Irreg. Size] for copying, you cannot use the Poster, Offset
Collate, Offset Group, Staple, 1 2-Sided, 2 2-Sided, Book 2-Sided,
2-Page Separation, Cover/Sheet Insertion, Image Combination, Booklet,
Job Block Combination, Tab Paper Creation or Store In User Inbox mode.
(See Chapter 2, "Introduction to the Copy Functions," in the Copying and
Mail Box Guide.)
• If you select [Irreg. Size] for printing documents stored in an inbox, you
cannot use the Offset Collate, Offset Group, Staple, 2-Sided, Booklet,
Cover/Sheet Insertion, Cover/Job Separator, or Tab Paper Creation mode.
(See Chapter 3, "Introduction to the Mail Box Functions," in the Copying
and Mail Box Guide.)
NOTE
For high-quality printouts, use paper recommended by Canon.
■ Standard Size
You can select standard inch paper, or A or B series paper.
■ Irreg. Size
You can load nonstandard paper sizes (139.7 mm x 182 mm to
330.2 mm x 487.7 mm).
1
Open the stack bypass.
NOTE
If the paper size you are going to load into the stack bypass is different from
the paper size stored in Stack Bypass Standard Settings, set Stack Bypass
Standard Settings to 'Off' in Common Settings (from the Additional
Functions screen). (See "Standard Paper for the Stack Bypass,"
on p. A4-38.)
Stack Bypass-A1 A3-25