Canon imagePRESS C7000VP Reference Manual page 380

4
Load the paper stack into the paper deck.
Make sure that the inside lifter has lowered before loading paper,
even out the edges of the paper stack, and stack the paper neatly
against the inner paper guide.
IMPORTANT
• Do not load paper into the paper deck that has been previously printed onto,
as this may result in a malfunction or damage to the copier. Always use the
stack bypass to feed paper when you want to print onto the back of a sheet
of paper that already has something copied on its front side (2nd side of
2-Sided print).
• Make sure that the size change plate is properly aligned with the marks of
the desired paper size. If the size change plate is not properly aligned, the
paper deck may become damaged.
• Paper which has been rolled or curled must be straightened out before
loading it into the paper deck.
• Make sure that the height of the paper stack does not exceed the loading
limit mark ( ) on the inside of the paper deck.
NOTE
• The paper decks hold approximately 3,500 sheets of paper (80 g/m
• Load the paper stack in stages, adding approximately 600 sheets of paper
2
(80 g/m ) at a time. If the paper deck can accommodate more paper, the
lifter will descend.
• Only load 330.2 mm x 482.6 mm, 320 mm x 450 mm (SRA3), 304.8 mm x
457.2 mm, A3, B4, A4, and B5 paper into the paper deck. Other than A4
paper cannot be loaded horizontally.
• For more information on the size change plate, see "Changing the Paper
Size for the Paper Deck-AC1," on p. A7-26.
• Hot air that is blown by the fan may warm the inner size change plate of the
paper deck.
• If there are instructions on the package of paper about which side of the
paper to load, follow those instructions.
• When paper is loaded in the paper deck, the side facing up is the one
printed on.
• If problems occur, such as poor print quality or paper jams, try turning the
paper stack over, and reload it. However, you cannot turn the texture paper
and 1-Sided Coated paper over. Change the new paper.
• For more information on the print direction of preprinted paper (paper which
has logos or patterns already printed on it), see "Relationship between
Original Orientation and Preprinted Paper Output Chart," on p. A9-10.
2
).
Paper Deck-AC1 (Optional) A7-25