Document Insertion Unit-C1 (Optional) - Canon imagePRESS C7000VP Reference Manual

Document Insertion Unit-C1 (Optional)

The optional Document Insertion Unit-C1 can be attached to the optional
Finisher-AB1 or Saddle Finisher-AB2.
When the Cover/Sheet Insertion, Cover/Job Separator, or Booklet (Saddle
Stitch Booklet) mode has been set, the document insertion unit feeds the
sheets to make a cover. The document insertion unit is necessary to feed
paper which cannot be fed from the main unit or paper deck (paper which has
been colour printed, etc.), for use as a cover.
IMPORTANT
• This section assumes that the optional Document Insertion Unit-C1 is
attached to the optional Finisher-AB1 or Saddle Finisher-AB2.
• Paper which has been rolled or curled must be straightened out before
placing it into the document insertion unit.
• Do not place the following types of paper into the document insertion unit.
Doing so may cause a paper jam.
- Insertion sheets with holes or tears
- Severely curled or wrinkled paper
- Tab paper
- Clipped or stapled insertion sheets
- Transparencies or other highly transparent insertion sheets
- Tracing paper
- Labels
• If you create a saddle stitched booklet using coated paper for the cover, the
image printed on the page after the cover may stick to the back of the cover,
depending on the type of coated paper you are using.
• If you create a saddle stitched booklet using coated paper for the cover,
cracks may appear around the fold of the cover, depending on the type of
coated paper you are using.
• If you use the Staple (Corner/Double) mode to staple multiple copy sets
using coated paper for the cover, the staples of copy sets may dirty the
surface of the cover of copy sets that have already been output, depending
on the type of coated paper you are using.
• Some types of paper cannot be used with the optional Document Insertion
Unit-C1. For more information, contact your local authorized Canon dealer.

Document Insertion Unit-C1 (Optional)

A7-34