Loading Paper - Canon imagePRESS C7000VP Reference Manual

Loading Paper

If you select the POD Deck when it has no paper, or if the POD Deck
runs out of paper during a print job, a screen prompting you to load
paper appears on the touch panel display.
Follow the procedure below to load paper into the POD Deck.
CAUTION
When loading paper, take care not to cut your hands on the edges of
the paper.
IMPORTANT
• Never place paper or any other items in the empty part of the paper deck
next to the paper stack. Doing so may cause paper jams.
• A paper blower is attached inside of the POD Deck. Do not insert paper
clips or other foreign objects into the blower port.
• A screen prompting you to load paper also appears if the selected paper
deck is not fully inserted into the machine. Make sure that the paper deck is
properly in place.
• You can load nonstandard paper if both of the sides are between 182 mm
and 487.7 mm in length, and between 182 mm and 330.2 mm in width. You
cannot load nonstandard paper if either one of the sides is shorter than
182 mm and longer than 487.7 mm in length, or longer than 330.2 mm in
width.
• Do not load the following types of paper into the POD Deck-A1/Secondary
POD Deck-A1 and Paper Deck-AC1. Doing so may cause a paper jam.
- Severely curled or wrinkled paper
- Thin straw paper
2
- Heavy paper (more than 300 g/m
2
- Thin paper (less than 64 g/m )
- Paper which has been printed on using a thermal transfer printer (Do not
print on the reverse side of this paper either.)
• Fan the stack of paper well before loading it, and align the edges of the
paper stack on a flat surface.
• The POD Deck can only accommodate paper from 64 to 300 g/m
weight.
POD Deck-A1/Secondary POD Deck-A1 (Optional)
)
2
in
A7-13