Canon imagePRESS C7000VP Reference Manual page 361

When loading paper into the paper deck, make sure that the paper
size setting is the same size of the paper that is being loaded.
IMPORTANT
• Do not subject the paper holder plate to shock when loading paper into the
paper deck, as this may result in a malfunction or damage to the machine.
• Do not load paper into the paper deck that has been previously printed onto,
as this may result in a malfunction or damage to the copier. Always use the
stack bypass to feed paper when you want to print onto the back of a sheet
of paper that already has something printed on its front side (2nd side of
2-Sided print).
• Paper which has been rolled or curled must be straightened out prior to use.
• Make sure that the height of the paper stack does not exceed the loading
limit mark ( ) at the back of the paper deck.
NOTE
• Each paper deck holds approximately 1,000 sheets of paper (80 g/m
• If there are instructions on the package of paper about which side of the
paper to load, follow those instructions.
• When the paper is loaded into the paper deck, the side facing down is the
one printed on.
• If problems occur, such as poor print quality or paper jams, try turning the
paper stack over, and reload it. However, you cannot turn the texture paper
and 1-Sided Coated paper over. Change the new paper.
• For more information on the print direction of preprinted paper (paper which
has logos or patterns already printed on it), see "Relationship between
Original Orientation and Preprinted Paper Output Chart," on p. A9-10.
6
Lower the paper holder plate.
2
).
Paper Decks A7-6