Stack Bypass-A1; Parts And Their Functions; Making Prints Using The Stack Bypass - Canon imagePRESS C7000VP Reference Manual

Stack Bypass-A1

If you are feeding paper manually, load the paper stock into the stack bypass.

Parts and Their Functions

a Slide Guides
Adjust the slide guides to match the size of the paper.
b Auxiliary Tray
Pull out the auxiliary tray if the paper size is large.
b
a

Making Prints Using the Stack Bypass

IMPORTANT
• Note the following points when using the stack bypass:
- Paper Quantity: one to approximately 100 sheets (80 g/m
approximately 10 mm high)
- Paper Size: 139.7 mm x 182 mm to 330.2 mm x 487.7 mm
- Paper Weight: 64 to 256 g/m
- Paper which has been rolled or curled must be straightened out prior to
use, to allow the paper to feed smoothly through the stack bypass
(allowable curl amount: less than 10 mm for normal paper, less than 5 mm
for heavy paper). There are some types of paper stock which may meet
the above specifications, but cannot be fed into the stack bypass.
• Do not load different size/type paper at the same time.
• Feed coated paper one sheet at a time. Loading several sheets together
may cause paper jams.
• Depending on the type of heavy paper you want to load, if you load multiple
sheets of heavy paper into the stack bypass, a paper jam may occur. In this
case, load only one sheet of heavy paper at a time.
• If you are making two-sided prints, select the 2-Sided mode. The printed
paper may crease depending on the moisture absorption condition of the
paper, and if you copy the two pages as two one-sided documents.
2
, stack
2

Stack Bypass-A1

A3-24