Table of Contents
Advertisement
6.4.1.
SATA M.2 Module Installation
A SATA Flash module may be connected to the CP6007 via the onboard connector, J18. This optionally available module
must be physically installed on the CP6007 prior to installation of the CP6007 in a system. During installation it is
necessary to ensure that the SATA Flash module is properly seated in the onboard connector J18, i.e. the pins are
aligned correctly and not bent.
SATA device fail message at boot-up: may be a bad cable or lack of power going to the drive
SATA device fail message at boot-up on Rear I/O module, caused by forced speed to 6.0Gb/s (see Chapter 2.7.6
"SATA Interfaces")
The CP6007 does not support removal and reinsertion of the M.2 storage card while the
board is in a powered-up state. Connecting the M.2 card while the power is on, which is
known as "hot plugging", may damage your system.
The CP6007 supports only single-sided M.2 modules. The heat sink for the M.2 module is
provided with the CP6007.
6.4.1.1. Installing a M.2 Card
To install a M.2 card:
1.
Remove the 4x mounting screws and then remove the M.2 heat sink from the CP6007.
2.
Align the connector on the M.2 card with the connector on the board. Make sure the slits are aligned with the
protrusions on the connector.
3.
Insert the M.2 card into the connector on the CP6007 board.
4.
Secure the M.2 card with the screw (provided with the CP6007).
5.
Re-install the M.2 heat sink removed in step 1.
Figure 13: Installing a M.2 Card
www.kontron.com
CP6007-SA, CP6007-RA – User Guide, Rev. 1.0
// 71
Advertisement
Table of Contents
