Table of Contents
Advertisement
6.3.2.
Hot Swap Removal
Prior to following the steps below, ensure that the safety requirements are met. When removing a board from the
system, particular attention must be paid to the components that may be hot, such as heat sink, etc.
To remove the CP6007 from a running system proceed as follows:
1.
Unlock the board ejection handles by pressing their release buttons.
The blue HS LED starts blinking indicating that the shutdown process has begun.
2.
After approximately 1 to 15 seconds, the HS LED turns on steady indicating that the CP6007 may be removed from
the system.
3.
Disconnect any interfacing cables that may be connected to the board.
4.
Unscrew the front panel retaining screws.
5.
Using the ejector handles, disengage the board from the backplane and remove it from the system.
www.kontron.com
CP6007-SA, CP6007-RA – User Guide, Rev. 1.0
// 69
Advertisement
Table of Contents
