Table of Contents
Advertisement
6/ Installation
This chapter is oriented towards an application environment. Some aspects may, however, be applicable to a
development environment.
6.1. Safety
To ensure personnel safety and correct operation of this product, the following safety precautions must be observed:
All operations involving the CP6007 require that personnel be familiar with system equipment, safety
requirements and the CP6007.
This product contains electrostatically sensitive components which can be seriously damaged by electrical static
discharge (ESD). Therefore, proper handling must be ensured at all times.
Whenever possible, unpack or pack this product only at EOS/ESD safe work stations. Where a safe work station is
not guaranteed, it is important for the user to be electrically discharged before touching the product with his/her
hands or tools. This is most easily done by touching a metal part of your system housing.
Do not handle this product out of its protective enclosure while it is not used for operational purposes unless it is
otherwise protected.
Do not touch components, connector-pins or traces.
Kontron assumes no liability for any damage resulting from failure to comply with these requirements.
6.2. General Instructions on Usage
In order to maintain Kontron's product warranty, this product must not be altered or modified in any way. Changes or
modifications to the device, which are not explicitly approved by Kontron and described in this manual or received
from Kontron's Technical Support as a special handling instruction, will void your warranty.
This device should only be installed in or connected to systems that fulfill all necessary technical and specific
environmental requirements. This applies also to the operational temperature range of the specific board version,
which must not be exceeded. If batteries are present, their temperature restrictions must be taken into account.
6.3. Board Installation
The CP6007 is designed for use either as a system board or as an autonomous CPU board in a peripheral slot.
When installed in the system slot, the CP6007 provides all required functions for supporting the hot swapping of
peripheral boards which are capable of being hot swapped.
When installed in a peripheral slot, the CP6007 operates autonomously, meaning that it only draws power from the
backplane.
6.3.1.
Hot Swap Insertion
Prior to following the steps below, ensure that the safety requirements are met.
To insert the CP6007 in a running system proceed as follows:
1.
Ensure that the board ejection handles are open.
2.
Insert the board into the slot designated until it makes contact with the backplane connectors.
3.
Using the ejector handles, engage the board with the backplane. When the ejector handles are closed, the board
is engaged.
4.
The blue HS LED turns on and then off indicating that the CP6007 is operating.
5.
Fasten the front panel retaining screws.
6.
Connect all external interfacing cables to the board as required.
www.kontron.com
CP6007-SA, CP6007-RA – User Guide, Rev. 1.0
// 68
Advertisement
Table of Contents
