Table of Contents
Advertisement
2.7.5.
Gigabit Ethernet
The CP6007-SA provides five Gigabit Ethernet interfaces. The CP6007-RA provides two further Gigabit Ethernet
interfaces in addition to the five interfaces of the -SA variant.
All Gigabit Interfaces are 10Base-T/100Base-T/1000Base-T compliant.
Table 11: Gigabit Ethernet Controller Port Mapping
ETHERNET CONTROLLER
Intel i219, Bus 0 Dev 0x1f, Function 6
Intel i350, Bus 2 Dev 0, Function 0
Intel i350, Bus 2 Dev 0, Function 1
Intel i350, Bus 2 Dev 0, Function 2
Intel i350, Bus 2 Dev 0, Function 3
Intel i210, Bus 3, Dev 0, Function 0
Intel i210, Bus 4 Dev 0, Function 0
Listed PCIe bus numbers are valid for a CP6007 board installed in peripheral slot booting
from NVMe M.2 module.
Intel i350 and i210 controllers are placed inside PCIe topology behind other optional PCIe
devices, which are only enabled if devices are present.
Depending on other PCIe devices, assigned Intel i350 and Intel i210 bus numbers will be
different.
Other PCIe devices are (lowest bus numbers listed first):
XMC slot (only enabled with installed XMC module)
PCIe-PCI-X bridge for CompactPCI backplane (only enabled if board is placed in system slot)
NVMe device (not present if SATA M.2 modules are used)
PCIe-PCI-X bridge for PMC slot (only enabled if PMC module is present)
Intel i350 function 0 – function 3
Intel i210 Front J11 (middle)
Intel i210 Front J12 (upper)
www.kontron.com
PORT MAPPING
Front Port J10 (lower connector)
Rear LAN, PICMG 2.16 LPb
Rear LAN, PICMG 2.16 LPa
Rear LAN, J3 LPd (CP6007-RA only)
Rear LAN, J3 LPc (CP6007-RA only)
Front Port J11 (middle connector)
Front Port J12 (upper connector)
CP6007-SA, CP6007-RA – User Guide, Rev. 1.0
IOL/SOL Channel (IPMI)
--
2
3
4
5
--
--
// 35
Advertisement
Table of Contents
