Table of Contents
Advertisement
Installation
Mounting of Flash Memory Modules (ref FDM-SATA-xxxx or FDM-USB-xxxx) :
4 Place washer.
4 Insert card.
4 Check alignment: the hole in card must match the hole in the heatsink of the VX3030 board.
4 Tighen nylon screw (no thread adhesive needed).
Order Code of the USB flash disk:
FDM-USB-xGB-2MM-IV: industrial version with conformal coating for use with rugged versions
(x = up to 16 GB)
Order Code of the SATA NAND drive flash disk:
FDM-SATA-xGB-C0V
(x= up to 32 GB)
Page 26
Figure 12: Flash Memory Module Installation
Figure 13: NAND Flash Disk Overview
VX3030 User's Guide
CA.DT.A87-5e
Advertisement
Table of Contents
