3/ Configuration; Dip Switch Configuration; Dip Switch Sw3; Table 25: Dip Switch Sw3 Functionality - Kontron CP6007-SA User Manual

3/ Configuration

3.1. DIP Switch Configuration

The DIP switches SW3 and SW4 are located near the front panel at the bottom side of CP6007.

Figure 8: Location of DIP Switch SW3 and SW4

3.1.1.

DIP Switch SW3

The DIP switch SW3 serves for general board configuration.

Table 25: DIP Switch SW3 Functionality

SWITCH
1
2
3
4
The default setting is indicated by using italic bold.
To clear the uEFI BIOS settings and the passwords, proceed as follows:
1.
Set DIP switch SW3, switch 4, to the ON position.
2. Apply power to the system.
3.
Wait 30 seconds and then remove power from the system. During this time period no messages are displayed. (If
power is not turned off, UEFI/BIOS starts with default settings).
4.
Set DIP switch SW3, switch 4, to the OFF position.
www.kontron.com
SETTING FUNCTIONALITY
OFF Boot-up with POST code indication on LED3–0
ON Boot-up with no POST code indication on LED3–0
OFF Boot from the standard SPI boot flash
ON Boot from the recovery SPI boot flash
OFF Non-volatile memory write protection disabled
(if no other write protection sources are enabled. Factory and user
EPROM only)
ON Non-volatile memory write protection enabled
OFF Boot using the currently saved uEFI BIOS settings
ON Clear the uEFI BIOS settings and use the default values
CP6007-SA, CP6007-RA – User Guide, Rev. 1.0
// 50