Rll Components Adjustment Rules; Buckles; General Information; Telescopic Buckles - Belarus 922.6 Operator's Manual

Table of Contents

4.3.3 RLL components adjustment rules

Buckles are used to limit side sway of lower links of the lift linkage both in transport

and in operating position. The tractors BELARUS-922.6 with hydraulic lift can be equipped

with telescopic buckles or outer turnbuckles.

ATTENTION: IN CASE OF CHANGE OF LENGTH OF A LIFTING ROD IT IS NEC-

ESSARY TO ADJUST BUCKLE LOCKS AGAIN IN TRANSPORT AND OPERATING PO-

SITIONS. NON-FULFILLMENT OF THIS REQUIREMENT MAY RESULT IN BREAK OF

LIMIT BUCKLES OR OTHER DAMAGE!

Back end of telescopic buckle 1 (Figure 4.3.2) is connected to the lower link 2, and

front end – is connected to bracket 3.

ATTENTION: IN TRACTOR BELARUS-922.6 IN ORDER TO AVOID DAMAGE THE

TELESCOPIC BUCKLES SHALL BE MOUNTED ONLY ON THE SECOND-FROM-THE-

BOTTOM HOLES IN BRACKETS (POSITION 2 IN FIGURE 4.3.3)! USE OF POSITIONS 1,

3 AND 4 ON THE BRACKET SHOWN IN FIGURE 4.3.3 IS FORBIDDEN!

Figure 4.3.3 – Mounting of buckle back end into the bracket

During tractor operation the telescopic buckles must always be blocked in one of the

three available positions:

- partial blocking of buckles in operating position;

- full blocking of buckles in operating position;

- full blocking of buckles in transport position.

During operation with some implements it is necessary to provide swaying of the im-

plement in each side for not less than 125 mm or other interval in compliance with the ma-

chine (implement) operation manual. For this purpose, buckles should be partially blocked.

1 – telescopic buckle; 2 –lower link; 3 –bracket.

Figure 4.3.2 – Telescopic buckles assembly

922.6-0000010 OM

Table of Contents

923.6