Rear Wheel Twinning; Front Wheel Track Formation - Belarus 922.6 Operator's Manual

Note – For information on track formation rules for rear wheels of different configura-
tion contact your dealer.

3.2.10 Rear wheel twinning

With an aim to improve gripping properties of the tractor when coupled with heavy
agricultural implements on soil with low bearing capacity, rear wheel twinning with use of
spacers is provided.
To get information on the rules of rear wheel twinning and operational restrictions for
the tractors with rear wheels twinned, contact your dealer!

3.2.11 Front wheel track formation

The front wheel track is adjusted in stages by displacing the wheels from one side-
board to the other and by changing a position of the wheel disk in relation to the rim.
The front wheel track may have the following dimensions: 1415, 1515, 1585, 1685,
1735, 1835, 1900, 2000 (for short beam), и 1535, 1635, 1705, 1805, 1855, 1955, 2020,
2120 (for long beam).
Diagrams of installation and track dimensions for tires 360/70R24 (basic configura-
tion) are given in table 3.2.7.
Table 3.2.7 – Front wheel track adjustment
Variants of mounting the
disk and the rim
Tractor track
К, mm
Disk
(tire
offset Х,
360/70R24)
mm
Short Long
beam beam
+140 1415 1535
+90 1515
635
-18 1735
855
83
Description of mounting method
Main position. The inner surface of the
disk mates with the gear group flange,
and the disk is located from the outer side
of the wheel support
Ex-works condition.
The rim is displaced relating to the disk.
1
The inner surface of the support mates
with the disk.
The rim is turned by 180°. The disk mates
1
with the support inner surface.
922.6-0000010 OM