Outer Turnbuckles - Belarus 922.6 Operator's Manual

Full blocking of buckles in transport position shall be made as follows:
- if buckles were fully blocked in operating position, you should check side-sway range of
the machine (implement) while it is lifted in up position, which shall not exceed 20 mm in each
side. Adjust buckle length when necessary, by turning screw 2 with handle 3;
- if buckles were partially blocked in operating position, you should make full blocking first
as stated above. After doing so, check side-sway range of the machine (implement) while it is
lifted in up position, which shall not exceed 20 mm in each side. Adjust buckle length when nec-
essary by turning screw 2 with handle 3.

4.3.3.1.3 Outer turnbuckles

During tractor operation outer turnbuckles must always be blocked in one of the three
available positions:
- partial blocking of turnbuckles in operating position;
- full blocking of turnbuckles in operating position;
- full blocking of turnbuckles in transport position.
Partial blocking of turnbuckles in operating position shall be made as follows:
- attach the machine (implement) to the lower links and lift it a little bit until it takes off
from the ground;
- set the machine (implement) symmetrically to the tractor longitudinal axis;
- turnbuckles must be attached to the lower bores of brackets 1, as is shown in of Figure
4.3.5;
- to achieve swinging of the implement for not less than 125 mm in each side or in ac-
cordance with machine operation manual, adjust turnbuckles 2 length by turning central element
А of the brace rods.
ATTENTION: ADHERE STRICTLY TO MACHINE SWING RATE OF NOT LESS THAN
125 MM IN ORDER TO AVOID TURNBUCKLES TENSION FRACTURE WHEN THE MA-
CHINE IS LIFTED TO TRANSPORT POSITION!
а) Partial blocking of outer turnbuckles
Full blocking of buckles in operating position shall be made as follows:
- attach the machine (implement) to the lower links and lift it a little bit until it takes off the
ground;
- set the machine (implement) symmetrically to the tractor longitudinal axis;
- the turnbuckles must be attached to the second lower bores of brackets 1, as is shown
in view b) of Figure 4.3.5b;
- check side-sway range of the machine (implement), it shall not exceed 20 mm in each
side;
- to limit swinging of the implement in each side for not more than 20 mm, adjust the
turnbuckles length 2 by turning central element A of the turnbuckles.
During mounting of RLL in transport position it is necessary to make full blocking of the
turnbuckles in transport position.
- if the turnbuckles were partially blocked in operating position, than in up position of the
1 – bracket; 2 – turnbuckle; 3 – limiting chain.
Figure 4.3.5 – Partial and full blocking of outer turnbuckles
b) Full blocking of outer turnbuckles
99
922.6-0000010 OM