Front Ballast Weights Installation - Belarus 922.6 Operator's Manual

Table.4.5.1 – Tractor "BELARUS-922.6" hydraulic drive specifications
Parameter description
1 Paired hydraulic outputs
2 Oil pipe for free draining into tank (free drain
line)
3 Total oil consumption through hydraulic out-
puts, l/min
4 Rated minimum diameter of oil pipeline, mm:
- oil pressure pipeline
- oil drain pipeline
5 Hydraulic system working pressure, MPa
6 Pressure relief cracking pressure, MPa
7 Allowable extraction of hydraulic fluid from a
tank, l, not more than
8 Allowable hydrostatic
(GSPTO) kW, not more than
9 Coupling thread
sleeves, mm:
1)
At rated engine speed
ATTENTION: INSTALLATION OF ADDITIONAL ELEMENTS AND CHANGE OF
HYDRAULIC LIFT LINKAGE PIPELINES ROUTE IS ALLOWED ONLY AFTER CONSUL-
TATION WITH THE PLANT OR THE DEALER!
Note – The arrangement of the HLL hydraulic outlets and the diagram of their con-
nection to the external consumers are given in section 2 "Controls and instruments".
4.6 Front ballast weight installation
When operating with heavy coupled implements and tools mount supplementary weights 1 (Fig-
ure 4.6.1) to retain normal steerability of the tractor under conditions of considerable unloading of the
front axle. The ballast weights 1 are mounted on a special bracket 6, which is attached to the front bar
5 of the tractor and is fastened by a pin 4 and a nut 7.
1 – supplementary ballast weights; 2 – bolt for fastening supplementary ballast weights and tow-
ing device; 3 – towing device; 4 – pin; 5 – form bar; 6 – bracket; 7 – nut.
Installation of two types of supplementary ballast weights is possible:
- 450 kg ballast weights (10 pieces 45 kg each);
- 360 kg ballast weights (8 pieces 45 kg each).
The basic configuration includes mounting of 450 kg ballast weights.
power take-off
of fast-coupling
Figure 4.6.1 – From ballast weight installation
value (characteristic)
Side
Two pairs
-
joint
112
922.6-0000010 OM
Parameter
Rear
One pair
-
1)
Up to 46
16,0
25,0
16,0
20
-2
10
12,0
М201,5