Attachment Of Implements To A Tractor - Belarus 922.6 Operator's Manual

Twin crossbar DH-ZH-01 6 (Figure 4.3.9) with kingpin 7 is optional supplied to the tele-
scopic lower links for operation with mounted agricultural implements. Tips 5 are mounted in-
stead of the links rear ends 4 (an eye is mounted on the middle hole of twin crossbar tips 5). In
this configuration the distance between the PTO end and the kingpin (coupling point) makes
400 mm. If it is necessary, you can adjust step by step the distance within
middle position changing the length of telescopic links.
Note – General parameters and characteristics of drawbar hitch DH-1ZH-01 are given in
subsection 4.4 "Drawbar hitch"

4.3.4 Attachment of implements to a tractor

During attachment of implements to a tractor, ensure that there are no people in the area
of implement attachment. Using RLL controls put down lower links up to the required level and
connect lower links hinge pivots with the implement and then connect upper link hinge pivot by
means of a pin. Use right lifting rod to adjust the implement position in transverse plane. To make
adjustments in fore-and-aft plane for alignment of depth of front and rear working attachments of
the implement change upper link length by turning link pipe to the corresponding direction.
Final adjustment of the machine shall be made in the field.
Before starting operation, ensure that:
- tractor parts are not in dangerous closeness to implement components;
- upper link does not touch PTO guard with the implement in lower position;
- cardan drive from PTO is not abnormally long, with bigger joint angles and that there is
no thrust force;
- PTO guard does not touch machine cardan drive guard;
- lift the implement slowly and check availability of clearances between tractor and im-
plement in up position;
- check availability of the required side oscillation of lower links and adjust by means of
buckles, when necessary.
WARNING: SOME TYPES OF MOUNTED OR SEMI-MOUNTED IMPLEMENTS CAN
TOUCH THE CAB AND DAMAGE IT. IT CAN RESULT IN DAMAGE OF THE CAB WINDOWS
AND CAUSE INJURY TO THE OPERATOR. CHECK AVAILABILITY OF CLEARANCES (NOT
LESS THAN 100 MM) BETWEEN UPLIFTED IMPLEMENT AND OPERATOR'S CAB!
Mount machines (implements) on a tractor by means of automatic coupler СА-1, con-
nected to the tractor lift linkage in three points (two rear hinge pivots of lower links and rear hinge
pivot of upper link).
102
922.6-0000010 OM
±
80 mm from the