Track Formation Of Rear Wheels, Mounted On Cone-Shaped Hubs - Belarus 922.6 Operator's Manual

- mount the wheel and tighten nuts 1 with a torque from 300 to 350Nm;
- set the other wheel track in the same way.
1 – nuts retaining wheel on hub; 2 – bolt retaining hubs on semiaxles.
Figure 3.2.5 – Tract setting for rear wheels, mounted on terminal hubs
Check the tightening of hub bolts and wheel retaining nuts after the first operation
hour, after the first eight – ten operation hours and every succeeding 125 operation hours.
Use Table 3.2.5 and Figure 3.2.6 to determine the track width by measuring distance
А from the semi-axle end to the hub end.
Table 3.2.5 – Rear wheel track setting options on terminal hubs
Note – For information on the rear wheel track setting rules on tyres of alternative
configuration contact your dealer.

3.2.9.2 Track formation of rear wheels, mounted on cone-shaped hubs

By order the tractor rear wheels can be mounted on cone-shaped hub groups which
consist of split conic bushings 3 and 4 (Figure 3.2.7) and hub group housing 2.
When installing the hub on the semi-axle, tighten bolts 1 to 360-380 N·m in the fol-
lowing order: 1, 2, 3, 4, 5, 6 (Figure 3.2.4b). When the wheel is mounted on the hub, tighten
bolts 1 to 360-400 N·m in the following order: 1, 2, 3, 4, 5, 6.
Figure 3.2.6 –Rear wheel track
Track width L, mm
1500
1600
1800
1900
2000
2100
Distance А, mm
50
0
164
114
64
14
81
922.6-0000010 OM