Indication Of Scr System Operation - Belarus 922.6 Operator's Manual

2 .26.2 Indication of SCR system operation

To look through SCR system parameters, it is required to press any button of the mon-
itor, except for button 5 (Figure 2.9.1), when the monitor is in the display mode of engine pa-
rameters. At that, a pop-up menu will switch on the monitor as shown in Figure 2.26.2b).
а) monitor in the display mode of
engine parameters
Figure 2.26.2 – Entry into display mode of SCR system parameters
After pressing the third button of the monitor located under the entry sign to the menu
of SCR parameters, the monitor passes into the display mode of SCR system parameters.
The monitor in the display mode of SCR parameters is shown in Figure 2.26.3.
1, 2, 3, 4 – push buttons of pop-up instrument board; 5 – button for entry to/exit from
the mode of setting contrast, brightness and configuration menu; 6 – three-section display of
SCR parameters on the screen.
Figure 2.26.3 – Monitor in the display mode of SCR parameters
When pressing any of buttons 1, 2, 3, 4 (Figure 2.26.3), pop-up menu 6 is switched on
the monitor (Figure 2.26.4). When pressing button 5 (Figure 2.26.3), entry to/exit from the mode of
setting contrast, brightness and configuration menu is carried out.
The monitor in the display mode of SCR parameters with the switched on pop-up instru-
ment board and the button assignment with the switched on pop-up instrument board are shown
in Figure 2.26.4.
1 – reset button to the display mode of engine parameters; 2 – rewind button for dis-
played SCR parameters; 3 – call button for graphic display of engine parameters; 4 – call
button for error (failure) list indication; 5 – reset button for the pop-up instrument board; 6 –
pop-up instrument board; 7 – three-section display of SCR parameters on the screen.
Figure 2.26.4 – Monitor in the display mode of SCR parameters with a switched on pop-up in-
b) monitor in the display mode of engine
parameters with a switched on pop-up
instrument board
strument board
67
922.6-0000010 OM
Sign of entry into
SCR parameters menu
Pop-up menu