Lowering Drive Wheel; Caster Wheels; Inflating Caster Tire - MacDon M205 Operator's Manual

Self-propelled windrower

Hide thumbs Also See for M205:

Table of Contents

Lowering Drive Wheel

This procedure is for lowering the drive wheel when it is raised on a jack stand. This procedure can be used on both

drive wheels.

Jack stand must be capable of supporting a minimum of 2268 kg (5000 lb.).

1. Place a jack under leg jack point (A), and raise the drive

wheel slightly off the jack stand.

2. Remove the jack stand from under cylinder lift mount

(B), and lower the drive wheel to the ground.

3. Remove the jack.

• Do NOT exceed maximum inflation pressure as per

label on tire.

• Use a safety cage if available.

• Do NOT stand over tire. Use a clip-on chuck and

extension hose.

• NEVER install a tube in a cracked wheel rim.

• NEVER weld a wheel rim.

• Make sure all the air is removed from a tire before

removing the tire from the rim.

MAINTENANCE AND SERVICING

Figure 5.213: Drive Wheel Leg Jack Point

Figure 5.214: Safely Filling a Tire with Air