7700 MultiFrame Manual
7710XUC-HD HD Format Up/Down/Cross Converter
2.5.
GENERAL PURPOSE INPUTS AND OUTPUTS
On all versions of the module, a 6-pin connector labeled GPIO contains four GPI/O inputs.
J80
+ 5
+ 12
VDC
VDC
3.6 K
to
internal
circuit
GPI
GPI
Command
GND
Figure 4: GPI Input Circuitry
The GPO is active low with internal pull up (10k Ohm) resistors to +5 V. When the output goes low, it is
able to sink up to 10 mA. When the output is high, the signal will go high (+5V). Do not draw more than
100µA from the output. Figure 5 shows the circuit for the general-purpose output. The GPO output is
not used at this time.
+ 5 Volts
10 K
10 ohm
GPO
From Internal
Circuit
GND
Figure 5: GPO Output Circuitry
7710XUC-HD
-8
Revision 1.0