Connecting To A Profile Rs-232 Port; Connecting The Hd9010-Sie To A Computer; Physical Connections; Table 2-6: Rs-422 Straight Through Cable - evertz HD9010-SIE Instruction Manual

RS422 Tributary port
Pin
1
2
3
4
5
6
7
8
9
2.8. CONNECTING TO A PROFILE RS-232 PORTWhen the HD9010-SIE is in RDR LVS or VTR LVS
mode, the COM1 serial remote control port is used to listen to a serial data stream from the Profile disk
recorder. This serial communication is normally daisy-chained to each of the HD9010-SIE units that are
connected on the Profile outputs. The serial port is used to obtain status, LVS and CTL information from
the Profile recorder. (See chapter 4 for a complete description of the serial port operation).
In order to properly address each of the HD9010-SIE units connected in the daisy chain, the Profile sends
out an 'address' before each command. The LVS ADDRESS menu item on the Utility menu of the
HD9010-SIE must be set to match the address that the Profile is using for a specific output.
2.9.

CONNECTING THE HD9010-SIE TO A COMPUTER

2.9.1. Physical Connections

A nine pin sub-miniature 'D' connector (COM 1) is provided for connection to a computer. This serial port
provides a bi-directional RS-232-C data link for upgrading firmware. In order to connect your HD9010-SIE
to your computer use standard 9 pin 'straight through' cable. See section 5.2 for a complete description of
how to upgrade the firmware. Contact the factory for further information about the serial data output. The
baud rate of this port is set using the COM 1 BAUD RATE menu item.
When the HD9010-SIE is in RDR LVS or VTR LVS mode, the receive input of the COM1 serial remote
control port is used to listen to a serial data stream from the Profile disk recorder. The transmit output of
the COM1 serial remote control port is used to transmit various debug messages.
INSTALLATION
HD9010-SIE High Definition Source ID Encoder Manual
VTR
Description
Frame Ground
Transmit A (Tx-)
Receive B (Rx+)
Receive Gnd
Spare
Transmit Gnd
Transmit B (Tx+)
Receive A (Rx-)
Frame Gnd

Table 2-6: RS-422 Straight Through Cable

Revision 1.2
SID Encoder
AUXCOM Serial Port
(RS422 Controller)
Pin Description
1 Frame Ground
2 Receive A (Rx-)
3 Transmit B (Tx+)
4 n/c
5 Spare
6 n/c
7 Receive B (Rx+)
8 Transmit A (Tx-)
9 Frame Gnd
Page 2-8