Tally Connections; Colour Reference Connections; Serial Port Connections; Table 2-1: Serial Control Pin Definitions - Rs-232 Dce Configuration - evertz 8010TM Instruction Manual

Model 8010TM SDI Time Code Master Manual

2.1.4. Tally Connections

FAULT TALLY OUT:
open circuit when the 8010TM is processing video normally.
grounded when the optional SDI bypass relay is active.

2.1.5. Colour Reference Connections

COL'R REF IN:

2.1.6. Serial Port Connections

SERIAL: A 9 pin female 'D' connector for connection to the RS-232/RS-422 serial
communications. See section 5.2.2 for the information on configuring the port for various
applications.
On the 8010TM this port is configured at the factory for a 'straight through RS-232 connection to a PC
COM port. In this configuration it can be used for uploading firmware to the unit or serial remote control.
Table 2-1 shows the pinout of the serial port in its default RS-232 DCE configuration.
Pin #
1
2
3
4
5
6
7
8
9

Table 2-1: Serial Control Pin Definitions - RS-232 DCE Configuration

This port can also be configured as an RS-422 tributary port for serial control applications. See section
5.2.2 for information on re-configuring the serial port. Table 2-2 shows the pinout of the serial port in its
RS-422 tributary configuration.
Pin #
1
2
3
4
5
6
7
8
9

Table 2-2: Serial Control Pin Definitions - RS-422 Tributary Configuration

Page 2-2
A BNC connector for output of a SMPTE 269M fault tally. The output will be
A BNC connector used to provide a colour-lock reference for the generator.
Name Description
GND Chassis ground
TxD RS-232 Transmit Output
RxD RS-232 Receive Input
Sig Gnd RS-232 Signal Ground
RTS RS-232 RTS Input
CTS RS-232 CTS Output
Name Description
GND Chassis ground
Tx- Transmit A (Tx-) Output
Rx+ Receive B (Rx+) Input
Tx Gnd Transmit Signal Ground
Spare Not connected
Rx Gnd Receive Signal Ground
Tx+ Transmit B (Tx+) Output
Rx- Receive A (Rx-) Input
GND Chassis ground
Revision 1.5.1
The output will be
INSTALLATION