Stratasys Connex500 User Manual page 3

Copyright
Copyright © 2014 Stratasys Ltd. All rights reserved.
This documentation contains proprietary information of Stratasys Ltd. This information is supplied
solely to assist authorized users of Connex500/350 3D printing systems. No part of this document may
be used for other purposes, and it may not be disclosed to other parties.
The specifications on which this document is based are subject to change without notice.
No part of this book may be reproduced in any form or by any means, nor stored in a database or
retrieval system, without prior permission in writing from Stratasys Ltd.
If this document is distributed as a PDF file, you may print it for internal use.
Trademarks
The following are registered trademarks of Stratasys Ltd.: Stratasys
The following are trademarks of Stratasys Ltd.: Connex, Connex500, Connex350, Objet260 Connex,
PolyJet, Objet Studio, Job Manager.
Microsoft and Microsoft XP are trademarks of Microsoft Corporation.
All names of products and services cited in this book are trademarks or registered trademarks of their
respective companies.
FCC Compliance
The equipment referred to in this guide has been tested and found to comply with the limits for a
Class A device pursuant to part 15 of the FCC rules. These limits provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. Objet 3D
printing systems generate, use and can radiate radio‐frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which case
the user will be required to correct the interference at his own expense.
The 3D printer referred to in this guide contains a transmitter module, FCC ID YH6‐RFID.
NOTE: Stratasys is not responsible for radio or TV interference caused by unauthorized modification
to this equipment. Such modification could void the user's authority to operate the equipment.
Equipment Recycling
In the European Union, this symbol indicates that when the last user wishes to discard a product, it
must be sent to appropriate facilities for recovery and recycling. For information about proper
disposal, check your purchase contract, or contact the supplier of the equipment.
Limitation of Liability
The product, software or services are being provided on an "as is" and "as available" basis. Except as
may be stated specifically in your contract, Stratasys Ltd. expressly disclaims all warranties of any
kind, whether express or implied, including, but not limited to, any implied warranties of
merchantability, fitness for a particular purpose and non‐infringement.
You understand and agree that Stratasys Ltd. shall not be liable for any direct, indirect, incidental,
special, consequential or exemplary damages, including but not limited to, damages for loss of profits,
goodwill, use, data or other intangible losses (even if Stratasys has been advised of the possibility of
such damages), resulting from: (i) the use or the inability to use the product or software; (ii) the cost of
procurement of substitute goods and services resulting from any products, goods, data, software,
information or services purchased; (iii) unauthorized access to or alteration of your products, software
or data; (iv) statements or conduct of any third party; (v) any other matter relating to the product,
software, or services.
The text and drawings herein are for illustration and reference only. The specifications on which they
are based are subject to change. Stratasys Ltd. may, at any time and without notice, make changes to
this document. Stratasys Ltd., for itself and on behalf of its subsidiaries, assumes no liability for
technical or editorial errors or omissions made herein, and shall not be liable for incidental,
consequential, indirect, or special damages, including, without limitation, loss of use, loss or alteration
of data, delays, or lost profits or savings arising from the use of this document.
DOC-13025 Rev. A
® ® ®
, Objet , FullCure .